Sitename Your slogan goes here

Overview

Strain link sensors picks up surface-strain between the 2 mounting locations.

The strain occuring between the mounting areas is mechanically amplified inside of the sensor.

The integrated digital amplifier processes the signal on the spot, avoiding EMC problems.

Thanks to the rugged design, this sensors are used in heavy industrial environment. In case of overload, this sensor may get an offset.

After replacing a SL-Sensor, they need to be recalibrated.

They need a cyclical reset (for cycles >1min.).

Our amplifier can handle the occuring large offset range.

Description

• Amplifies the strain between the 2 mounting areas mechanically
• Ideal for tension mode
• With high end digital amplifier type 268 (active)
• Mainly for dynamic applications
• Use don presses and injection moulding machines
• Solid steel housing (IP54)

Overview

Strain link sensors picks up surface-strain between the 2 mounting locations.

The strain occuring between the mounting areas is mechanically amplified inside of the sensor.

The integrated AC amplifier supplies a signal that needs no reset -> the signal drops even if the load remains present.

Ideal for very fast cycles where a reset between the cycles is not possible.

The controler only needs to measure the output signal periodically.

Thanks to the rugged design, this sensors are used in heavy industrial environment.

Description

• Amplifies the strain between the 2 mounting areas mechanically
• Ideal for tension mode
• With integrated AC coupling amplifier (active)
• For Dynamic applications (even fast)
• Ideal on fast running Presses
• Solid steel housing (IP54)

Overview

Strain link sensors picks up surface-strain between the 2 mounting locations.

The strain occuring between the mounting areas is mechanically amplified inside of the sensor.

The integrated amplifier amplifies the signal on the spot, avoiding EMC problems.

Thanks to the rugged design, this sensors are used in heavy industrial environment.

In case of overload, this sensor may get an offset.

After replacing a SL-Sensor, they need to be recalibrated.

They need a cyclical reset (for cycles >1min.).

Our amplifier can handle the occuring large offset range.

Description

• Amplifies the strain between the 2 mounting areas mechanically
• Ideal for tension mode
• With analog amplifier (active)
• Dynamic applications
• Presses and injection moulding machines
• Solid steel housing (IP54)
• Analog amplifiers are economical

Overview

The strain gauge sensor SB46 measure the surface-strain directly at the mounting location in the same quality as bonded strain gages.

The press-on technology, developed by Sensormate AG, presses the strain gauges under the stainless protective film so strongly against the surface to be measured that frictional contact occurs.

The sensor can not be overloaded. The mounting is easy and very fast. The sensor do not need a recalibration when it replaced or remounted.

The sensor need a cyclical reset.

Description

• Small press-on sensor with one-hole mounting
• Direct measurement of surface strain
• Without amplifier (passiv)
• High accuracy and linearity in tension and pressure (like bonded strain gauges)
• For dynamic applications
• Used on presses, injection moulding and die-casting machines
• Quick and easy mounting
• Protected against overload
• Optional accessories: - Signal amplifier VDA - Monitor DU-1D